AFMG Network Forum

jonessy · Member

Hi All,

In my model, the RT ranges from 12 secs (at LF) to 1.9 secs (at HF).
When I run AURA, it calculates the response only up to ~ 300ms...

Even when I set the 'length' parameter manually to about 12000 ms, it still doesn't calculate the entire response.

How can this be fixed?

Kind regards,
Jon

AFMG Pedro Lima · Forum Moderator

Hello Jonessy,

Would it be possible for you to send me the Project? Please, Pack it via EASE Main window > File menu > Pack Project, before sending. You can send to Pedro.Lima@AFMG.eu

Best Regards,
Pedro

jonessy · Member

Sent.

Regards,
Jon.

AFMG Pedro Lima · Forum Moderator

Jonessy,

While our development team give this problem a deeper investigation, you can try to export your model as DXF and then reimport it to EASE again. This should be enough to solve your problem and will allow you to run AURA calculations with no problem again.

Also notice that, on EASE EYES, it is not possible to see all the faces. Specially the ceiling ones. It should be related to your problem.

Please return to me if you have further questions,
Best Regards,

AFMG Pedro Lima · Forum Moderator

BTW,

To export to DXF:
- Open your Project on EASE;
- Open EASE IMEX from the File menu > Import / Export;
- Next, from the Tools pulldown menu, choose Export DXF;

To import to DXF:
- Perform the same procedure but this time choose Import DXF/SKP

HTH

jonessy · Member

Thanks for the workaround...

Seems like it gets the job done.

Cheers,
Jon.